Off-road vehicle winch to drag the specific steps are:

    1, first check the drum. Before you begin, make sure that the noose is neatly wound around the drum.
    2, if the noose out, should prevent it from swinging back and forth. If the noose is broken, the ropes can be very dangerous. However, this danger can be avoided, as long as the mattress in a tight put a mat on the line.
    3, start dragging, if the rope with his own car, and you have to drive in the car, then the best one in the car to help you. In this way, the driver can operate the Fromwinch heavy duty ATV winch in the vehicle in accordance with the instructions of the outside commander.
    4, if the twisted cable together, and must pull it open. Windings can easily intersect the drum or become uneven on one side. Therefore, pay close attention to its status.
    5, when the car is free to walk, the drag is complete. Once back on the ground, check the condition of the vehicle and the line. If you can not rely on external force to start the car, the use of Fromwinch portable truck winch drag the process is over.
    6, the roll is good. Tighten the noose and carefully return it. If the noose crosses or twists on the drum, it must be completely undone and then rewound.
    7, and finally put the hook. When the noose is only the last point, tie the hook to the side of the winch. And then the rest of the little noose rolled up, the hook to suppress.
    8. Remove the remote control.